GUIDE 01Beginner15 min
Steady a wobbly chair
Find the loose joint, re-glue and clamp, then snug every fastener so the wobble never comes back.
- 1.Flip the chair and find the play
- 2.Back out loose screws, add glue
- 3.Re-drive and let it set
// WORKSHOP — DIY GUIDES
Fix the stuff on your list.
Short, practical guides for the repairs everyone puts off — each one paired with the Leenpro kit that gets it done.
GUIDE 02Beginner20 min
Unstick a sticking door
Diagnose whether it's the hinge, the swelling or the strike plate — then fix the actual cause.
- 1.Mark where it rubs
- 2.Tighten or shim the hinge
- 3.Sand or plane the high spot
GUIDE 03Beginner30 min
Hang a shelf dead level
Mark studs, snap a level line and anchor properly so the shelf holds the weight you actually put on it.
- 1.Find studs and snap a line
- 2.Check level twice
- 3.Anchor and load-test
GUIDE 04Intermediate30 min
Fix a leaky sink trap
Most under-sink drips are a loose slip nut or a tired washer. A wrench and ten minutes usually does it.
- 1.Bucket under the trap
- 2.Loosen the slip nuts
- 3.Replace washer, hand-tight + quarter turn
GUIDE 05Beginner10 min
Clean cuts for craft & models
Score-and-snap technique for clean edges on card, foam and vinyl — with safe blade handling.
- 1.Fresh blade, cutting mat
- 2.Light scoring passes, not one deep cut
- 3.Retract the blade every time you set it down
GUIDE 06Intermediate45 min
Build a straight gallery wall
Lay it out on the floor, transfer to the wall with a chalk line, and hang each frame level.
- 1.Arrange on the floor first
- 2.Transfer marks with a tape + square
- 3.Hang from the center out
Not sure which kit?
Browse all twelve, or tell us the job and we'll point you to the right one.